 |
Standard
Press
Model CS4100
For more information or pricing on any of these
products, please contact us.
General Description
The machine is
a versatile, fully-automated, single axis, closed loop
hydraulic testing system specifically designed to perform
tests on various specimens over a wide range of stresses
and frequencies. The system has sufficient flexibility to
perform in a variety of environments: university research,
special tests and standard tests required by state DOTs
and other government agencies. The design ensures the
easiest possible interface with the operating technician.
Specifications
- Microsoft NT operating system
- CPU - 866 MHz Intel Pentium III
processor
- National Instruments 16 bit, 16
channel data acquisition board
- National Instruments LabVIEW
Software
- 17 inch high-resolution monitor
- Capacity - 266kN (60,000 lbf.)
- Vertical clearance between
platens - 470 mm (18.5 in.)
- Clearance between columns - 559
mm 22 in.)
- Hydraulic system - 5 hp (3.5 kw)
- Dimension - 1,905 mm (75")W,
990 mm (39")D, 2,336 mm (92")H
- Shipping weight - 998 kg
(2,200lb.)
OPERATING
SOFTWARE
Test Screens
You can view these screen capture images
by clicking the thumbnail to enlarge
|
CONTROL SELECTION
Quick selection of templates used in the system. |
BASIC CONTROL
Provides machine control and access to the
templates for programming transducer set-up,
calibration, etc. |
FUNCTION GENERATOR
Provides the operator with the ability to program
custom testing sequences in force and position
control. |
|
TRANSDUCER SET-UP
Allows access to all transducer channels for
programming changes in gains, voltage to engineering
units, offsets, etc. |
TRANSDUCER
CALIBRATION
A highly effective procedure for rapid calibration
of the system's transducers. A polynomial
curve-fitting procedure is used to obtain the best
curve through collected points. |
EXUDATION TEST
Automatically performs the exudation phase of
California Test Method 301. At the end of test "Word
Pad" appears showing test data formatted for optional
spread sheet entry. |
|
STABILOMETER
RESISTANCE TEST
Automatically performs the stabilometer phase of
California Test Method 301. At the end of test "Word
Pad" appears showing test data formatted for optional
spread sheet entry. |
STABILOMETER VALUE
TEST
Automatically performs the exudation phase of
California Test Method 366. At the end of test "Word
Pad" appears showing test data formatted for optional
spread sheet entry. |
LIMITS
Automatically turns off the hydraulic actuator to
provide protection for expensive fixtures when load
(force) or stroke (position) limits are exceeded. |
For more information or pricing on any of these
products, please contact us. |
)
)
)
)
)
)
)
)
)